Electric Submersible Seawater Pump
Overview
With compact structure, corrosion resistant, less land occupation, noiseless and easy to realize auto control, and especially suitable for shallow water working conditions.
Consists of pump shaft, impeller, casing, suction bell, wear ring, check valve, intermediate flange and other parts ，fully apply to marine environment for firefighting, lifting water ,cooling and other purposes.r many industries.
Characteristics
● Multistage single suction centrifugal pump
● Seawater lubrication bearing
● Rigid coupling connection between pump and motor
● Impeller design with high efficiency hydraulic model, save operation costs
● Connected vertically between pump and motor, small installation space
● Impeller fixation on shaft by stainless steel key
● When using in seawater or similar corrosive liquid, the main material is normally nickel-aluminum bronze, Monel alloy or stainless steel
Design Feature
● The distance of inlet to the sea bottom not less than 2m
● The whole set of the pump should submerged in the depth not exceeding 70m to sea level
● Anti-clockwise rotation viewed from above
● Seawater speed on the motor surface ≥0.3m/s
● The inside of motor must be filled up with clean water, 35% coolant and 65%water in winter according to need
Motor structure
● The top of motor bearing assembled with mechanical seal and sand prevention ring is for prevent sand and other impurities enter into motor
● Motor bearings are lubricated by clean water
● Stator windings are wound with polyethylene insulation nylon covered water resistant magnet winding
● The top of motor have an inlet hole, vent hole, the bottom have a plug hole
● Thrust bearing with groove, withstand the pump’s upper and lower axial force
Performance
